Skip to content
MappleCare Community ↗
Solved Question Apple Watch & AirPods

[Solved] AirPods Pro 2 AirPods Pro 2 Static Noise in Earbud During ANC Mode (Firmware 7B19) – Verified Troubleshooting

Started by Margaret Wolf • November 16, 2026 at 1:13 am • 1 Community Replies • 2 Participants

Home › Forums › Apple Watch & AirPods › [Solved] AirPods Pro 2 AirPods Pro 2 Static Noise in Earbud During ANC Mode (Firmware 7B19) – Verified Troubleshooting

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #36463
    Margaret Wolf
    Senior Specialist (Lvl 8)
    Diagnostic Hardware Specs: AirPods Pro 2 (USB-C) | OS Version: Firmware 7B19 | Archive Source: Apple Support Community #256689606

    I am running into a persistent issue on my AirPods Pro 2 (USB-C) running Firmware 7B19.
    Whenever the machine encounters Acoustic debris clogging outer beamforming microphone mesh, the following diagnostic log appears in Console:

    CoreAudio: [SpatialAudio] Phase cancellation feedback loop detected in Left transducer

    I verified that hardware connections are intact and tested across different power sources. What is the verified diagnostic procedure to permanently eliminate this symptom?

    MacBook Air 15″ M3 (24GB) | CalDigit TS4 Dock | Kensington Orbit | Minneapolis, MN
    Enterprise Mac Sysadmin & Jamf Pro Architect | "Verified Apple Discussions Archive"
    #36464
    Elliott Douglas
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Deep cleaning outer black microphone mesh using dry adhesive putty and performing 15-second case reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Remove silicone ear tip. Press dry Blu-Tack adhesive putty firmly against the outer oval microphone grilles and pull away sharply.
    2. Place AirPods in case, close lid 30s. Open lid, hold back button for 15s until LED flashes amber, then white.
    3. Re-pair with iPhone. If noise persists, visit Apple Store for acoustic fixture testing.

    Following this procedure restores full stability with zero recurring log errors.

    iPhone 15 Pro (256GB) | Apple Watch Series 10 | Sydney, NSW
    Apple Certified Support Professional (ACSP) | Pro Audio Recording Engineer
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.