Skip to content
[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 ProMappleCare Community ↗

[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Started by Gareth Riley • November 18, 2026 at 7:13 am • 1 Community Replies • 2 Participants

Home › Forums › Battery, Charging & Thermal Care › [Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #84572
    Kullanıcı ProfiliGareth Riley
    Community Contributor
    Diagnostic Hardware Specs: MacBook Pro 14″ M2 Pro | OS Version: macOS Sequoia 15.1 | Archive Source: Apple Support Community #256008009

    I am running into a persistent issue on my MacBook Pro 14″ M2 Pro running macOS Sequoia 15.1.
    Whenever the machine encounters SMC Power Delivery controller handshake fault, the following diagnostic log appears in Console:

    AppleSmartBattery: [Power] MagSafe 3 EPR 28V/5A handshake negotiation rejected: resistance anomaly

    I verified that hardware connections are intact and tested across different power sources. What is the verified diagnostic procedure to permanently eliminate this symptom?

    Mac Studio M3 Ultra (192GB) | Pro Display XDR 6K | Sydney, NSW
    HomeKit / Matter IoT Integrator | "Verified Apple Discussions Archive"
    #84573
    Kullanıcı ProfiliJonathan Reid
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
    2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
    3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

    Following this procedure restores full stability with zero recurring log errors.

    Mac Pro 2023 M2 Ultra (192GB) | Promise Pegasus R8 | Copenhagen, Denmark
    Apple Certified Support Professional (ACSP) | CoreML & On-Device AI Researcher
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.