Skip to content
[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 ProMappleCare Community ↗

[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Started by Kathleen Gomez • November 18, 2026 at 6:51 pm • 1 Community Replies • 2 Participants

Home › Forums › Battery, Charging & Thermal Care › [Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #95819
    Kullanıcı ProfiliKathleen Gomez
    Senior Specialist (Lvl 8)
    Diagnostic Hardware Specs: MacBook Pro 14″ M2 Pro | OS Version: macOS Sequoia 15.1 | Archive Source: Apple Support Community #256103190

    I am running into a persistent issue on my MacBook Pro 14″ M2 Pro running macOS Sequoia 15.1.
    Whenever the machine encounters SMC Power Delivery controller handshake fault, the following diagnostic log appears in Console:

    AppleSmartBattery: [Power] MagSafe 3 EPR 28V/5A handshake negotiation rejected: resistance anomaly

    I verified that hardware connections are intact and tested across different power sources. What is the verified diagnostic procedure to permanently eliminate this symptom?

    MacBook Pro 14″ M3 Pro (36GB) | Focusrite Clarett+ 8Pre | Beyerdynamic DT 1990 | Portland, OR
    Logic Pro Audio Producer & Mixing Engineer | "Verified Apple Discussions Archive"
    #95820
    Kullanıcı ProfiliAlex Tanner
    Lead Moderator
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
    2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
    3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

    Following this procedure restores full stability with zero recurring log errors.

    MacBook Air 15″ M3 (24GB) | AirPods Pro 2 | Boston, MA
    Apple Certified Support Professional (ACSP) | Biomedical Engineer
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.