Skip to content
[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 ProMappleCare Community ↗

[Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Started by Owen Russell • November 16, 2026 at 8:32 pm • 1 Community Replies • 2 Participants

Home › Forums › Battery, Charging & Thermal Care › [Solved] How to fix MagSafe 3 Blinking Amber LED and Refusing to Charge caused by SMC Power Delivery controller handshake fault on MacBook Pro 14″ M2 Pro

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #50447
    Kullanıcı ProfiliOwen Russell
    Community Contributor
    Diagnostic Hardware Specs: MacBook Pro 14″ M2 Pro | OS Version: macOS Sonoma 14.6 | Archive Source: Apple Support Community #256116287

    I am running into a persistent issue on my MacBook Pro 14″ M2 Pro running macOS Sonoma 14.6.
    Whenever the machine encounters SMC Power Delivery controller handshake fault, the following diagnostic log appears in Console:

    AppleSmartBattery: [Power] MagSafe 3 EPR 28V/5A handshake negotiation rejected: resistance anomaly

    I verified that hardware connections are intact and tested across different power sources. What is the verified diagnostic procedure to permanently eliminate this symptom?

    iMac 24″ M4 (32GB, Orange) | AirPods Max USB-C | Edinburgh, UK
    Audio Unit & CoreAudio Architect | "Verified Apple Discussions Archive"
    #50448
    Kullanıcı ProfiliLeo Chapman
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
    2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
    3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

    Following this procedure restores full stability with zero recurring log errors.

    Mac Studio M3 Ultra (192GB) | Pro Display XDR 6K | Melbourne, VIC
    Apple Certified Support Professional (ACSP) | Senior iOS / Swift Developer
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.