Skip to content
[Solved] MacBook Pro 16″ M3 Max MagSafe 3 Blinking Amber LED and Refusing to Charge (macOS Sequoia 15.1) – Verified TroubleshootingMappleCare Community ↗

[Solved] MacBook Pro 16″ M3 Max MagSafe 3 Blinking Amber LED and Refusing to Charge (macOS Sequoia 15.1) – Verified Troubleshooting

Started by Justin Green • November 16, 2026 at 10:07 pm • 1 Community Replies • 2 Participants

Home › Forums › Battery, Charging & Thermal Care › [Solved] MacBook Pro 16″ M3 Max MagSafe 3 Blinking Amber LED and Refusing to Charge (macOS Sequoia 15.1) – Verified Troubleshooting

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #52064
    Kullanıcı ProfiliJustin Green
    Community Contributor
    Diagnostic Hardware Specs: MacBook Pro 16″ M3 Max | OS Version: macOS Sequoia 15.1 | Archive Source: Apple Support Community #256688247

    I am running into a persistent issue on my MacBook Pro 16″ M3 Max running macOS Sequoia 15.1.
    Whenever the machine encounters SMC Power Delivery controller handshake fault, the following diagnostic log appears in Console:

    AppleSmartBattery: [Power] MagSafe 3 EPR 28V/5A handshake negotiation rejected: resistance anomaly

    I verified that hardware connections are intact and tested across different power sources. What is the verified diagnostic procedure to permanently eliminate this symptom?

    Mac Studio M3 Ultra (192GB) | Pro Display XDR 6K | Boston, MA
    Mac Sysadmin & DevOps Engineer | "Verified Apple Discussions Archive"
    #52065
    Kullanıcı ProfiliDaisuke Parker
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
    2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
    3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

    Following this procedure restores full stability with zero recurring log errors.

    iPad Air 13″ M2 (256GB) | Apple Pencil Pro | Auckland, New Zealand
    Apple Certified Support Professional (ACSP) | Pro Audio Recording Engineer
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.