Skip to content
MappleCare Community ↗

MappleCare Community

MappleCare Community Forums

Independent peer-to-peer Apple troubleshooting rooms • 100% English • Not affiliated with Apple Inc.

All Forum Rooms

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Laurent Jones
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
    2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
    3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

    Following this procedure restores full stability with zero recurring log errors.

    Mac Studio M2 Max (64GB) | LG UltraFine 5K | Zurich, Switzerland
    Apple Certified Support Professional (ACSP) | SwiftUI & VisionOS Specialist
    Laurent Jones
    Community Contributor
    Apple Recommended / Verified Community Solution
    This canonical solution was verified and marked as solved in the Apple Support Community archive.

    Locking refresh rate to a fixed frequency, disabling Variable Refresh Rate (VRR), and regenerating WindowServer display plists.

    Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

    1. In System Settings > Displays, set Refresh Rate to fixed 120Hz or 100Hz instead of Variable (VRR).
    2. Reset display preferences:
      sudo rm -f /Library/Preferences/com.apple.windowserver.displays.plist
      rm -f ~/Library/Preferences/ByHost/com.apple.windowserver.displays.*.plist
      killall -9 WindowServer
    3. In monitor physical OSD menu, set DisplayPort mode to ‘DP 1.4 Standard’ without aggressive DSC overdrive.

    Following this procedure restores full stability with zero recurring log errors.

    Mac Studio M2 Max (64GB) | LG UltraFine 5K | Zurich, Switzerland
    Apple Certified Support Professional (ACSP) | SwiftUI & VisionOS Specialist
Viewing 2 posts - 1 through 2 (of 2 total)