MappleCare Community
MappleCare Community Forums
Independent peer-to-peer Apple troubleshooting rooms • 100% English • Not affiliated with Apple Inc.
Forum Replies Created
Viewing 2 posts - 1 through 2 (of 2 total)
-
AuthorPosts
-
November 15, 2026 at 11:38 pm in reply to: [Solved] Matter Accessory Showing ‘No Response’ in Apple Home App on tvOS 18.1: Diagnostic steps and permanent fix #35680
Owen KellyCommunity ContributorApple Recommended / Verified Community SolutionThis canonical solution was verified and marked as solved in the Apple Support Community archive.Enabling IGMP snooping / multicast forwarding and rebooting primary Thread Border Router.
Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:
- In home router Wi-Fi settings, enable IGMP Snooping and disable ‘AP Isolation’.
- Power cycle your primary Thread Border Router (Apple TV 4K connected via Gigabit Ethernet).
- Power-cycle the unresponsive Matter accessory for 10 seconds to prompt a fresh Thread mesh re-route.
Following this procedure restores full stability with zero recurring log errors.
MacBook Pro 14″ M4 Pro (48GB) | CalDigit TS4 | Melbourne, VICApple Certified Support Professional (ACSP) | Xcode Build Matrix ArchitectNovember 15, 2026 at 10:05 pm in reply to: [Solved] Apple Vision Pro 1TB + Mac Studio M2 Ultra Mac Virtual Display Ultra-Wide Mode Connection Dropping (visionOS 2.1 + macOS Sequoia 15.1) – Verified Troubleshooting #34425
Owen KellyCommunity ContributorApple Recommended / Verified Community SolutionThis canonical solution was verified and marked as solved in the Apple Support Community archive.Locking Wi-Fi to a dedicated 5GHz/6GHz SSID, toggling AirPlay Receiver, and renewing Handoff tokens.
Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:
- Ensure both Mac and Vision Pro are connected to the exact same 5GHz/6GHz Wi-Fi band without band-steering.
- On Mac, open System Settings > General > AirPlay & Continuity and toggle AirPlay Receiver off and on.
- In visionOS Control Center, bring Mac Virtual Display window within 2 meters, select Connect, and set resolution to Ultra-Wide (4K equivalent).
Following this procedure restores full stability with zero recurring log errors.
MacBook Pro 14″ M4 Pro (48GB) | CalDigit TS4 | Melbourne, VICApple Certified Support Professional (ACSP) | Xcode Build Matrix Architect -
AuthorPosts
Viewing 2 posts - 1 through 2 (of 2 total)