[Rebecca Rogers]

Apple Recommended / Verified Community Solution

This canonical solution was verified and marked as solved in the Apple Support Community archive.

Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

Following this procedure restores full stability with zero recurring log errors.

Mac Studio M1 Ultra (64GB) | BenQ SW321C | Final Cut Pro 11 | Lyon, FR

Apple Certified Support Professional (ACSP) | Final Cut Pro / DaVinci Colorist & Editor

[Rebecca Rogers]

Apple Recommended / Verified Community Solution

This canonical solution was verified and marked as solved in the Apple Support Community archive.

Deep cleaning outer black microphone mesh using dry adhesive putty and performing 15-second case reset.

Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

1. Remove silicone ear tip. Press dry Blu-Tack adhesive putty firmly against the outer oval microphone grilles and pull away sharply.
2. Place AirPods in case, close lid 30s. Open lid, hold back button for 15s until LED flashes amber, then white.
3. Re-pair with iPhone. If noise persists, visit Apple Store for acoustic fixture testing.

Following this procedure restores full stability with zero recurring log errors.

Mac Studio M1 Ultra (64GB) | BenQ SW321C | Final Cut Pro 11 | Lyon, FR

Apple Certified Support Professional (ACSP) | Final Cut Pro / DaVinci Colorist & Editor

[Rebecca Rogers]

Apple Recommended / Verified Community Solution

This canonical solution was verified and marked as solved in the Apple Support Community archive.

Completely discharging GaN brick capacitors, cleaning pogo pins with 99% IPA, and triggering PMU cold reset.

Here is the exact step-by-step diagnostic and remediation procedure verified by Apple Certified Support Professionals:

1. Unplug power brick from the wall and disconnect MagSafe cable. Wait 2 full minutes for capacitors to discharge.
2. Clean the 5 gold spring-loaded pins with 99% isopropyl alcohol and a lint-free swab.
3. Plug adapter directly to wall, connect MagSafe to Mac, and power on. The LED will illuminate steady amber.

Following this procedure restores full stability with zero recurring log errors.

Mac Studio M1 Ultra (64GB) | BenQ SW321C | Final Cut Pro 11 | Lyon, FR

Apple Certified Support Professional (ACSP) | Final Cut Pro / DaVinci Colorist & Editor

[Author]

Posts