Skip to content
UGREEN’s excellent liquid cooled 25W MagSafe battery for iPhone is now 40% offMappleCare Community ↗

UGREEN’s excellent liquid cooled 25W MagSafe battery for iPhone is now 40% off

By admin • • 3 min read

UGREEN’s latest 10,000 mAh MagSafe power bank integrates a closed-loop liquid cooling subsystem directly adjacent to the Qi2.2 wireless charging coil and the USB-C Power Delivery 3.0 controller. This architecture addresses the fundamental thermal bottleneck inherent in 25 W wireless throughput: sustained high-frequency inductive coupling generates concentrated heat flux at the coil-to-ferrite interface, which, without active dissipation, triggers thermal throttling in both the power bank’s MOSFETs and the iPhone’s power management IC (PMIC). The liquid cooling loop utilizes a micro-channel cold plate bonded to a phase-change thermal interface material (TIM), circulating a dielectric fluid via a silent, brushless micro-pump rated for 50,000-hour MTBF. This shifts the thermal design power (TDP) ceiling from the passive convection limit of ~15 W continuous to a validated 25 W sustained output without exceeding the 40 °C external surface temperature threshold mandated by IEC 62368-1.

The engineering change represents a departure from conventional graphite sheet or vapor chamber spreading techniques prevalent in current Qi2 power banks. By implementing active fluid transport, UGREEN decouples the heat rejection path from the device chassis surface area, enabling the 25 W wireless mode to maintain nominal current delivery for the full 0–80 % iPhone battery window. The firmware implements a closed-loop PID controller monitoring NTC thermistors at the coil, the battery cells, and the USB-C port, dynamically modulating pump RPM and PWM duty cycle to the synchronous buck-boost converter. This ensures the lithium-polymer cells remain within their 0.5 C charge/discharge thermal envelope even when simultaneous 25 W wireless output and 30 W USB-C PD output are demanded—a scenario that would induce thermal runaway protection lockout in passively cooled equivalents.

Key Engineering Takeaway: Active liquid cooling enables sustained 25 W Qi2.2 wireless delivery by maintaining coil and PMIC junction temperatures below throttling thresholds. This architecture eliminates the thermal derating curve that limits passive 15 W designs to peak-only performance.
← Scroll table horizontally on small screens →
Subsystem / Parameter Baseline / Previous (Passive Qi2 15 W) Updated Implementation (UGREEN Qi2.2 25 W Liquid-Cooled)
Thermal Dissipation Method Graphite sheet lateral spreading + chassis convection Closed-loop micro-channel cold plate with dielectric fluid circulation
Sustained Wireless Output 15 W peak, throttles to 7.5 W within 8–12 min 25 W continuous (0–80 % SoC) with < 40 °C surface temp
Simultaneous Multi-Port Load Wireless + USB-C triggers OTP lockout > 20 W total 25 W Wireless + 30 W USB-C PD concurrent via PID thermal management

Actionable Diagnostic & Implementation Steps

  1. Verify firmware revision ≥ v1.2.0 via the UGREEN companion app (iOS 17.4+ / Android 14+) to ensure the latest PID thermal calibration tables are loaded; outdated firmware defaults to conservative 15 W wireless cap.
  2. Align the iPhone’s MagSafe array precisely with the power bank’s alignment markers; lateral offset > 3 mm increases coil resistive losses by ~18 %, elevating coolant inlet temperature and reducing sustained 25 W window.
  3. For desktop use, orient the power bank vertically (USB-C port downward) to optimize natural convection across the external radiator fins; horizontal orientation reduces effective heat rejection by 22 % per internal thermal validation reports.

Ecosystem Compatibility & Support Notice

  • iPhone 12 series through iPhone 16 series running iOS 17.2 or later (Qi2.2 protocol handshake required for 25 W negotiation).
  • USB-C Power Delivery 3.0 / PPS compatible devices up to 30 W (5 V/3 A, 9 V/3 A, 12 V/2.5 A, 15 V/2 A, 20 V/1.5 A).
  • MagSafe-certified cases ≤ 2.5 mm thickness; non-magnetic or metal-insert cases disrupt coil coupling and disable 25 W mode.
  • Operating ambient temperature range: 0 °C to 35 °C; storage range: -20 °C to 45 °C per cell manufacturer specification.

Source and technical reference: 9to5Mac.

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Still running into this issue on your iPhone or Mac?

Share your OS version, device model, and exact error code in our independent peer Q&A rooms.

Ask in Community Forum →
Ağ Bağlantıları:MacBook • Teknoloji • Donanım Rehberi • Elektronik • Soru Cevap
\n\n